UNT Libraries Government Documents Department - 87 Matching Results

Search Results

Accommodating oversize and overweight loads: technical report

Description: "In this report the research project resulted in a statewide map recommending primary and alternate Oversize/ overweight (OS/OW)route networks for the most common origins and destinations based on historical Motor Carrier Division data. Keeping strategic routes open for OS/OW loads and minimizing the number of reroutes along the way will reduce the impedance and unknowns in this critical segment of the motor carrier industry."
Date: July 2012
Creator: Middleton, Daniel R.; Li, Yingfeng; Le, Jerry & Koncz, Nicholas

Alternative methods for developing external travel survey data

Description: The Texas Department of Transportation (TxDOT) has a comprehensive on-going travel survey program that supports the travel demand models being developed for transportation planning efforts in urban areas throughout Texas. One component of the survey program is the external travel survey. External travel surveys provide data on travel movements into, out of, and through urban areas. In recent years, there has been a heightened sensitivity to the methods used to collect external survey data as well as the type of data that is collected. This research examines alternative methods for collecting data on external travel movements and evaluates the potential for synthesizing/modeling external travel in lieu of conducting external surveys. The research will provide recommendations to TxDOT on the most viable methods to estimate external travel movements for use in travel demand models in urban areas in Texas.
Date: October 2010
Creator: Farnsworth, Stephen; Talbot, Eric; Songchitruksa, Praprut; Reeder, Phillip & Pearson, David

Alternative methods of flexible base compaction acceptance

Description: "This report summarizes the concerns expressed with the current Texas Department of Transportation(TxDOT) methods, presents approaches some TxDOT districts have taken to overcome problems, and summarizes the current status of other agencies' efforts at mechanistic based acceptance for flexible base. Also this report presents results and findings from a full-scale compaction experiment."
Date: May 2012
Creator: Sebesta, Stephen; Taylor, Ross. & Frazier, James.

Applying the systems engineering approach to video over IP projects

Description: "In 2009, the Texas Transportation Institute produced for the Texas Department of Transportation a document called Video over IP Design Guidebook. This report summarized an implementation of that project in the form of a workshop. The workshop was developed and presented as a pilot in Austin in 2010 and taught an additional four times in 2011 in Fort Worth, Lubbock, Houston, and San Antonio."
Date: September 2011
Creator: Thomas, Gary B.

Benefits of Public Roadside Safety Rest Areas in Texas : technical report

Description: Report regarding efforts to develop a benefit-cost analysis methodology for safety rest areas in Texas and to demonstrate its application in select corridors throughout the state. This project also considers approaches to developing rest areas that could reduce costs to the public.
Date: May 2011
Creator: Carson, Jodi L.; Pezoldt, Val J.; Koncz, Nicholas A., 1964- & Obeng-Boampong, Kwaku Oduro, 1977-

Characterization of exhaust emissions from heavy-duty diesel vehicles in the Houston-Galveston-Brazoria area

Description: "For this study, a total of 30 heavy-duty diesel vehicles (HDDVs) were selected from City of Houston (COH) fleet based on opacity testing for HEs and random selection for non-HEs. With the selected 30 vehicles, driving and idling emission testing were performed to characterize their emissions with respect to vehicle classes, types (HE or non-HE), and model years."
Date: October 2011
Creator: Johnson, Jeremy D.; Lee, Doh-won; Farzaneh, Reza; Zietsman, Josias & Yu, Lei

Collision Loads on Bridge Piers: Phase 2. Report of Guidelines for Designing Bridge Piers and Abutments for Vehicle Collisions

Description: "An instrumented, simulated bridge pier was constructed, and two full-scale collisions with an 80,000-lb van-type tractor-trailer were performed on it. The trailer was ballasted with bags of sand on pallets. The simulated pier was 36 inches in diameter and was supported in the longitudinal direction by two load cells. Force-versus-time data were obtained from the load cells."
Date: March 2011
Creator: Buth, Eugene; Brackin, Michael S.; Williams, William F. & Fry, Gary T.

Comprehensive evaluation of compaction of asphalt pavements and development of compaction monitoring system

Description: "This report aimed to conduct a comprehensive evaluation of compaction of asphalt pavements and develop software for monitoring field compaction in real time.The results were used to determine the effects of compaction temperature, compaction method, mixture design, and base type on the compactability of asphalt mixtures.Also in this report researchers developed a system for monitoring and documenting the compaction process of asphalt mixtures called compaction monitoring system (CMS)."
Date: April 2012
Creator: Kassem, Emad Abdel-Rahman, 1979-; Scullion, Tom; Masad, Eyad; Chowdhury, Arif; Liu, Wenting; Estakhri, Cindy K. et al.

Delivery of workshops on corridor management and preservation in Texas

Description: "This report summarizes the delivery and outcome of a series of workshops conducted at 23 Texas Department of Transportation (TxDOT) districts across the state on corridor management and preservation in Texas. The workshops served as follow-up implementation work for research project 0-5606, "Creating Partnerships with Local Communities to Manage and Preserve Corridors." The report provides an overview of the project and documents the dates, locations, and attendance of workshops implemented during the three-year project period."
Date: September 2010
Creator: Bochner, Brian S. & Hard, Edwin N.

Development guidance for sign design standards

Description: "This two-year project was designed to provide TxDOT with comprehensive review and update of mounting details and standards for large and small sign supports, and to provide a mechanism for TxDOT to quickly and effectively evaluate and address high priority needs related to sign support systems."
Date: November 2011
Creator: Silvestri, Chiara; Arrington, Dusty R.; Bligh, Roger P. & Menges, Wanda L.

Development of a MASH TL-2 guardrail-to-bridge rail transition compatible with 31-inch guardrail

Description: The TxDOT Design Division is in the process of developing new guardrail standards that comply with the AASHTO Manual for Assessing Safety Hardware (MASH). The new guardrail system will provide increased capacity and improved impact performance relative to the current design. A key feature of the new system is an increased in rail mounting height from 27 inches to 31 inches. TxDOT's current TL-2 metal beam transition is 27 inches tall and is not compatible with the new 31 inch guardrail system. While the high-speed, nested thrie beam transition system meets MASH guidelines and is compatible with a 31-inch guardrail, it would be cost-prohibitive to use it on all roadways. The objective of this research was to develop a transition that is suitable for use on lower speed roadways, less expensive and complex than the current high-speed (i.e., TL-3) transition design, and is compatible with a 31-inch guardrail. A low-cost guardrail-to-bridge rail transition was successfully developed and tested under MASH Test Level 2 conditions. It is compatible with a 31-inch guardrail and can connect to rigid concrete bridge rails. It is considered suitable for implementation on roadways that have traffic conditions appropriate for the use of TL-2 safety hardware. Use of this system provides significant savings in material and installation cost compared to the high speed transition system.
Date: December 2011
Creator: Bligh, Roger P.; Arrington, Dusty R. & Menges, Wanda L.

Development of a MASH TL-3 median barrier gate

Description: Report regarding a median barrier gate designed to both offer protection to motorists and easier cross-median access for emergency and maintenance vehicles.
Date: February 2011
Creator: Bligh, Roger P.; Arrington, Dusty R.; Sheikh, Nauman Mansoor; Silvestri, Chiara & Menges, Wanda L.

Development of a model performance-based sign sheeting specification based on the evaluation of nighttime traffic signs using legibility and eye-tracker data

Description: "This report focused on the evaluation of traffic sign sheeting performance in terms of meeting the nighttime driver needs. Using the luminance requirements derived from the study and market-weighted headlamp flux matrices, the researchers developed an approach to sigh sheeting specification that is based on nighttime driver needs."
Date: September 2010
Creator: Carlson, Paul J.; Miles, Jeffrey D.; Park, Eun Sug; Young, Sarah; Chrysler, Susan & Clark, Jerremy

Development of a model performance-based sign sheeting specification based on the evaluation of nighttime traffic signs using legibility and eye-tracker data : data and analysis

Description: "This report presents data and technical analyses for Texas Department of Transportation Project 0-5235. This project focused on the evaluation of traffic sign sheeting performance in terms of meeting the nighttime driver needs. The goal was to develop a nighttime driver needs specification for traffic signs. Full information on the project is presented in Report 0-5235-1 Volume 1."
Date: September 2009
Creator: Carlson, Paul J.; Park, Eun Sug & Miles, Jeffrey D.

Development of a precast bridge deck overhang system

Description: This research investigated the overhang and shear capacity of a precast overhang system for potential use during the construction of bridges with precast overhang panels. The research was performed in three phases: the Phase 1 research including work specifically for the Rock Creek Bridge in Parker County, Texas; the Phase 2 research for general precast overhang panels, and; the Phase 3 research investigating the shear capacity. Grout material characteristics were also assessed for possible use in the haunch; constructability issues were also addressed.
Date: February 2011
Creator: Trejo, David; Head, Monique H.; Mander, John; Mander, Thomas J.; Henley, Mathew; Scott, Reece et al.

Development of field performance evaluation tools and program for pavement marking materials: technical report

Description: The objective of this project is to investigate field evaluation plans and procedures and develop field performance-based evaluation procedures for pavement marking materials (PMMs). Field decks are designed incorporating regular long lines, long line in the travel lane, and transverse lines for accelerated testing, while also considering different installation procedures. Three different test field deck sites are selected across the state considering area climate, roadway surface type, and traffic condition. Carefully selected PMM products are installed and monitored for their field performance over time. The relationships between transverse and longitudinal test decks are evaluated with correlation analysis. A tracking database is developed and can record and interactively query all relevant data, track individual jobs and products, and graphically display performance changes over time.
Date: March 2011
Creator: Zhang, Yunlong; Ge, Hancheng; Pike, Adam & Carlson, Paul J.

Development of guidelines for pedestrian safety treatments at signalized intersections

Description: "This document summarized the research conducted and the conclusions reached during the development of guidelines for pedestrian safety treatments at signalized intersections. The guidelines are focused on treatments that alleviate conflicts between left-turning vehicles and pedestrians."
Date: August 2011
Creator: Pratt, Michael P.; Songchitruksa, Praprut & Bonneson, James A.

Development of precast bridge deck overhang system: technical report

Description: "The testing and analyses documented in this report (0-6100-3) provides a new equation for determining the number of shear pockets required for the various shear connector/coupler systems evaluated in this research. This equation was used to determine the number of shear pockets required for the newer TxDOT girders."
Date: February 2010
Creator: Kim, Young Hoon & Trejo, David

Development of Texas Transportation Institute's asphalt compaction monitoring system

Description: "In recent years, the Texas Department of Transportation has made significant progress with the development and implementation of new technologies to measure the uniformity of new hot mix asphalt layer construction. In Project 0-6992, researchers took this check one step further by developing an accurate global positioning system tracking system for compaction rolling so that the compaction effort applied can be monitored for 100 percent of the new surface. This report presents details of the hardware and software developed in this study. The system was field tested on a number of new overlay projects in Texas."
Date: July 2012
Creator: Liu, Wenting; Scullion, Thomas & Kassem, Emad

Development of the Transportation Revenue Estimator and Needs Determination System (TRENDS) forecasting model: MPO sub-models and maintenance

Description: "This report summarizes the technical work performed developing and incorporating Metropolitan Planning Organization sub-models into the existing Texas Revenue Estimator and Needs Determination System (TRENDS) model. Additionally, this report explains the maintenance and monthly updates performed on the TRENDS model."
Date: September 2011
Creator: Glover, Brianne; Norboge, Nicolas. & Ellis, David